Simple to install, easy to use, and built for everyday bathroom use.
01
The Science Behind Teaser Target™
Teaser Target™ uses a special heat-reactive thermochromic coating that responds to temperature.
At Rest
When the target is cool, it appears as a plain black oval and the hidden image is completely covered.
Activated
When warm liquid contacts the target, the thermochromic coating turns clear, revealing the hidden image underneath.
Ready Again
As the target cools, the image disappears and the black oval returns, resetting the target for the next use.
The Science Behind the Placement
Where the target is placed matters, too. Teaser Target™ is designed to provide a visible aiming point in a carefully selected location inside the bowl.
Research into urinal/toilet target placement indicates that providing a visible aiming point can naturally encourage users to aim toward it, while proper placement can help direct the stream toward areas that reduce splash.
Sources: Siegel (1977), Journal of Applied Behavior Analysis; Brigham Young University Splash Lab, Urinal Dynamics (2013); Bullinger et al., Splash-free urinals for global sustainability and accessibility (2025).
02
Installation & Care
Follow these steps for proper placement and best results.
1
Choose Your Target
Pick your favorite Teaser Target design and get ready to turn bathroom breaks into target practice.
2
Clean the Surface
Clean the inside of the toilet bowl where the target will be installed. Remove any dirt, residue, or cleaning product buildup and dry the area completely.
3
Check the Water Level
Make sure the target will be installed above the waterline. If your toilet has an unusually high water level, lower it before installation.
4
Peel & Stick
Before peeling the backing, check the numbered orientation guide shown with your target to determine the correct position. You can also hold the target between your hands and position it inside the bowl before peeling the backing to make sure the image will be oriented the way you want.
Remove the backing and place the target on the inside of the bowl above the waterline.
5
Press Firmly
Press firmly across the entire target for 10–15 seconds to ensure good adhesion.
6
Take Aim
You're all set! Teaser Target is designed to encourage better aim while making bathroom breaks more fun.
7
Watch the Magic Happen
Warm liquid activates the special heat-reactive coating, revealing the hidden image underneath.
8
Clean as Normal
Continue cleaning your toilet as you normally would. Teaser Targets are designed to withstand everyday bathroom use and routine cleaning.
03
Changing or Removing Your Teaser Target™
Ready for a different target? Removal is straightforward.
1
Lift a Corner
Using your fingernail or a plastic scraper, gently lift one corner of the target.
2
Peel Away
Slowly peel away as much of the target as possible. Applying gentle heat with a hair dryer can help soften the adhesive and make removal easier.
3
Remove Any Remaining Material
After extended use, some target material may remain on the surface. If needed, use a scraper or putty knife to gently remove any remaining material.
4
Wipe Clean
Wipe the area with your normal bathroom cleaner.
5
Install a New Target
Once the surface is clean and dry, you're ready for a fresh Teaser Target adventure.
04
Helpful Tips
Install above the waterline.
Apply only to a clean, dry, smooth porcelain surface.
For best results, place the target where it is easy to see while standing.
If the hidden image doesn't appear immediately, adjust your aim and try again.
In long-term testing, Teaser Targets remained installed for months and removed without leaving sticky adhesive residue behind.
Warning: Adult supervision is recommended during installation and removal.
QUICK REMINDER
Clean. Dry. Above the Waterline.
A clean, dry porcelain surface and proper placement give your Teaser Target the best start.